Bradex Bx60 Battery Charger Manual Full |best| May 2026

Bradex BX60 is a 12V 4A battery charger designed for standard lead-acid car batteries. It is valued for its straightforward analog design, featuring an easy-to-read ammeter and built-in safety protections against short circuits and reverse polarity. Quick Setup Guide

To safely use your Bradex BX60, follow these steps in order to prevent sparks or damage to your vehicle's electronics: Preparation

: If possible, remove the battery from the vehicle to avoid corrosive spills on engine parts. Ensure all vehicle accessories are turned off. Check Fluid Levels

: For non-sealed batteries, remove cell caps and top up with distilled water if the liquid is low. Connect the Clamps RED (+) Lead : Connect to the positive terminal of the battery. BLACK (-) Lead : Connect to the negative terminal. bradex bx60 battery charger manual full

: Plug the charger into a standard AC mains outlet. The charging process will begin automatically. Monitor the Ammeter

Initially, the needle will point to the right, indicating a high charging rate.

As the battery fills, the needle will slowly move to the left. Bradex BX60 is a 12V 4A battery charger

: The needle will never drop completely to zero, even when the battery is fully charged. Key Features & Safety Reverse Polarity Protection

: If you connect the leads incorrectly, the ammeter needle will swing back and forth continuously. If this happens, unplug the charger immediately and reverse the connection. Thermal Overload

: The unit contains a temperature-sensitive switch that will cut power if it becomes excessively hot, resetting itself once it cools down. Double Insulation Inspect battery for physical damage, bulging, or leaks—do

: This design ensures no earthing is required for the unit during indoor use. Specifications at a Glance Output Rating 12V DC – 4 Amp RMS Input Rating 230V ~ 50Hz Compatible Batteries 12V Lead-Acid car batteries Environment For indoor use only

For additional support or professional testing, you can find local automotive services through platforms like Tayna Batteries or retailers like estimated charging time for a specific battery size using this 4A charger? Bradex BX60 Battery Charger 12V 4A


4. Precharging checks

  1. Inspect battery for physical damage, bulging, or leaks—do not charge a damaged battery.
  2. Check the battery’s nominal voltage (12 V) and chemistry; ensure compatibility.
  3. Clean battery terminals and cable clamps of corrosion; use a wire brush if needed.
  4. Verify electrolyte levels in serviceable (non-sealed) cells and top up with distilled water if levels are low—do not overfill.
  5. Place the vehicle or battery in a well-ventilated area and remove metal jewelry to avoid accidental shorting.

8. Special Features & Modes

Step 1: Prepare the Battery