Canon Ir1024 Default Admin Password ✦ Updated

Canon iR1024 Default Admin Password Guide

If you are trying to access the System Management settings on a Canon iR1024, iR1024A, or iR1024iF, you will need the System Manager ID and PIN. Below are the default credentials and instructions on how to use them.

Frequently Asked Questions

Q: Is the Canon IR1024 default admin password the same as the IR1024i or IR1025?

A: Yes. The imageRUNNER 1024, 1024i (with fax), and 1025 all share the same default credential set: ID 7654321, password 7654321.

1. Check for a Sticker on the Machine

Some units have a small white label inside the front cover or on the back panel with a custom factory password. This is rare but worth checking.

Step-by-Step Web Login:

  1. Find the printer’s IP address:

    • Press Additional Functions > System Settings > Network Settings > TCP/IP Settings > IPv4 Settings.
    • Note the IP address (e.g., 192.168.1.100).

  2. Open a web browser (Internet Explorer or Firefox works best; modern Chrome may show security warnings but still functions).

  3. Enter the IP address into the address bar: http://[IP_Address]

  4. Click the System Manager Mode login tab (not User Mode). Canon Ir1024 Default Admin Password

  5. Enter the credentials:

    • System Manager ID: 7654321
    • Password: 7654321

  6. Click Login.

Once inside, you can configure everything from email alerts to LDAP authentication. Canon iR1024 Default Admin Password Guide If you

Method 2: Remote UI (Web Browser – Easiest)

The Remote UI gives you full access without standing at the machine.

  1. Find the printer’s IP address:
    • Press Additional Functions → System Settings → Network Settings → IPv4.
  2. On a computer connected to the same network, open a browser.
  3. Type http://[IP-address-of-printer] (e.g., http://192.168.1.20).
  4. Click System Manager Mode (sometimes labeled “Administrator Login”).
  5. Enter the default password from the table above (try blank first).
  6. Click Login.

Success gives you access to all admin settings: change the admin password, set a department ID, or reconfigure the network.

Alternative: Partial Reset (Keep Network Settings)

If you only need to access the admin panel and do not want to lose the IP address or scan destinations, try this less destructive method: Find the printer’s IP address:

  1. Turn off the device.
  2. Press and hold Additional Functions + 4 while powering on.
  3. Release when "RAM CLEAR" appears.
  4. Select USER DATA RESET ONLY (not "ALL RESET").
  5. Reboot. The admin password will revert to default, but IP and network settings may remain.

Limitation: This does not work on all IR1024 revisions. If you still cannot login, you must perform the full reset.

How to Access the Admin Panel (Two Methods)

Frequently Asked Questions (FAQ)