Gunnebo Speedstile Fl Installation Manual Now

Before delivery, the installation site must meet specific structural standards to ensure the stability of the speed gate cabinets. Floor Levelness : The finished floor must be flat and level to within plus or minus over the entire footprint area. Concrete Strength : The base should be concrete with a minimum resistance of Minimum Foundation Dimensions : Recommended at 2000mm x 500mm x 150mm deep (or as specified for cabinet length). Bolting Depth : Anchors require a minimum bolting depth of www.gunneboentrance.ru 2. Conduit & Cabling Preparation

Cables must rise from the foundation into the designated shaded areas within the cabinet base. Conduit Depth : Conduits should run at least 140mm below finished floor level. Conduit Rise : Conduits must rise at least 50mm from the foundation to prevent water ingress. Conduit Diameter : Use a minimum diameter of Power Supply : Standard operation requires 230Vac / 50Hz (115Vac available as an option). Power rating is roughly 120VA on standby 300VA during operation Fichet Security Solution 3. Installation Steps Gunnebo SpeedStile FLS Installation Guide | PDF - Scribd gunnebo speedstile fl installation manual

3.2 Adjusting Sensitivity (Anti-Tailgating)

The installation manual provides a detailed matrix for adjusting the tailgating detection threshold. The default setting detects a separation of 30 cm between two people. For high-security zones, you can increase sensitivity to 10 cm, but this increases false alarms. The manual recommends starting at "Standard" (Level 3/5) for the first week of use. Before delivery, the installation site must meet specific

Software configuration & commissioning

  1. Access the controller UI
    • Connect a laptop to the controller via Ethernet or USB. Use the manufacturer’s software or web UI.
  2. Set parameters
    • Lane mode (single pass, bi-directional), throughput timing, anti-tailgate sensitivity, reset timers, and alarm thresholds.
  3. Reader mapping
    • Map in/out readers to the correct lane direction and define statuses for accepted, denied, or pending passages.
  4. Alarm handling
    • Configure local alarm outputs and networked alarm events to building management or security consoles.
  5. Logs & event reporting
    • Set logging levels, event retention, and clock sync (NTP) if IP-connected.
  6. Save configuration
    • Backup configuration to a file and store it off-site for quick recovery.

Introduction

In the world of high-security entrance automation, the Gunnebo SpeedStile FL stands as a benchmark for speed, aesthetics, and robustness. Whether deployed in corporate headquarters, stadiums, or government buildings, this waist-high optical turnstile is designed to manage pedestrian traffic flow while preventing tailgating. Software configuration & commissioning

However, a piece of hardware is only as good as its installation. The Gunnebo SpeedStile FL installation manual is the essential blueprint for ensuring the unit functions correctly from day one. This article provides an exhaustive overview of what the manual contains, critical installation steps, common pitfalls, and maintenance schedules—bridging the gap between the official documentation and real-world application.

Disclaimer: This guide is a supplementary overview. Always refer to the official Gunnebo SpeedStile FL installation manual provided with your specific model serial number. Improper installation voids warranties and compromises security.

Share This