Reset Eprom Epson 1410 Adjustment Program New Better ❲UPDATED — VERSION❳

Resetting EPROM on Epson 1410 Using an Adjustment Program

8. Troubleshooting

• Connection fails: reinstall drivers, try different USB cable/port, disable firewall/antivirus temporarily.
• Reset option grayed out: ensure the utility is run with admin privileges and the correct model is selected.
• Error persists after reset: physically inspect waste-ink pads and sensors; replace sensors if faulty; check for firmware locks.
• If using third-party software, ensure it supports Epson 1410 specifically — model mismatches can brick settings.

Technical Procedure: Resetting Epson 1410 EPROM via Adjustment Program

Subject: Epson Stylus Photo 1410 Maintenance Objective: Reset Waste Ink Pad Counter (EPROM) using Adjustment Program Difficulty Level: Intermediate Risk Warning: High. Incorrect use of adjustment programs can permanently brick the printer.

---

Phase B: Software Execution

1. Extraction: Extract the downloaded Adjustment Program folder (usually a .zip or .rar file) to a location on the Desktop. Do not run it directly from the zip file.
2. Launcher: Locate the AdjProg.exe file. Right-click and select "Run as Administrator" (Highly recommended for proper driver access).
3. Model Selection:
   • The utility will open.
   • Select "Accept" on the license agreement.
   • In the "Model Name" dropdown, select Epson Stylus Photo 1410 (or 1400/1410 series depending on the specific build).
   • Ensure the "Destination" matches your region (usually leave as default).
   • Click "OK".